Sunday, August 30, 2009
Thursday, April 10, 2008
Competing technologies
Competing technologies
Within the marketplace, WiMAX's main competition comes from existing widely deployed wireless systems such as UMTS and CDMA2000, as well as a number of Internet oriented systems such as HIPERMAN and WiBro.
[edit] 3G and 4G cellular phone systems
Both major 3G systems, CDMA2000 and UMTS, compete with WiMAX. Both aim to offer DSL-class Internet access in addition to phone service. UMTS has also been enhanced to compete directly with WiMAX in the form of UMTS-TDD, which can use WiMAX oriented spectrum and provides a more consistent, if lower bandwidth at peak, user experience than WiMAX.
3G cellular phone systems usually benefit from already having entrenched infrastructure, being upgraded from earlier systems. Users can usually fall back to older systems when they move out of range of upgraded equipment, often relatively seamlessly.
The major cellular standards are being evolved to so-called 4G, high bandwidth, low latency, all-IP networks with voice services built on top. With GSM/UMTS, the move to 4G is the 3GPP Long Term Evolution effort. For AMPS/TIA derived standards such as CDMA2000, a replacement called Ultra Mobile Broadband is under development. In both cases, existing air interfaces are being discarded, in favour of OFDMA for the downlink and a variety of OFDM based solutions for the uplink, much akin to WiMAX.
In some areas of the world the wide availability of UMTS and a general desire for standardization has meant spectrum has not been allocated for WiMAX: in July 2005, the EU-wide frequency allocation for WiMAX was blocked.
Mobile Broadband Wireless Access
Mobile Broadband Wireless Access (MBWA) is a technology being developed by IEEE 802.20 and is aimed at wireless mobile broadband for operations from 120 to 350 km/h. The 802.20 standard committee was first to define many of the methods which were later funneled into Mobile WiMAX, including high speed dynamic modulation and similar scalable OFDMA capabilities. It apparently retains fast hand-off, Forward Error Correction (FEC) and cell edge enhancements.
The Working Group was temporarily suspended in mid 2006 by the IEEE-SA Standards Board since it had been the subject of a number of appeals, and a preliminary investigation of one of these "revealed a lack of transparency, possible 'dominance,' and other irregularities in the Working Group".[19]
In September 2006 the IEEE-SA Standards Board approved a plan to enable the working group to continue under new conditions, and the standard is now expected to be finalized by Q2 2008.
Internet-oriented systems
Early WirelessMAN standards, the European standard HIPERMAN and Korean standard WiBro have been harmonized as part of WiMAX and are no longer seen as competition but as complementary. All networks now being deployed in South Korea, the home of the Wibro standard, are now WiMAX.
As a short-range mobile Internet solution, such as in cafes and at transportation hubs like airports, the popular Wi-Fi 802.11b/g system is widely deployed, and provides enough coverage for some users to feel subscription to a WiMAX service is unnecessary.
WiMAX Spectrum Owners Alliance
WiSOA is the first global organization composed exclusively of owners of WiMAX spectrum with plans to deploy WiMAX technology in those bands. WiSOA is focussed on the regulation, commercialisation, and deployment of WiMAX spectrum in the 2.3–2.5 GHz and the 3.4–3.5 GHz ranges. WiSOA are dedicated to educating and informing its members, industry representatives and government regulators of the importance of WiMAX spectrum, its use, and the potential for WiMAX to revolutionise broadband
WiMAX Forum
The WiMAX Forum is the organization dedicated to certifying the interoperability of WiMAX products. Those that pass conformance and interoperability testing achieve the "WiMAX Forum Certified" designation and can display this mark on their products and marketing materials. Some vendors claim that their equipment is "WiMAX-ready", "WiMAX-compliant", or "pre-WiMAX", if they are not officially WiMAX Forum Certified.
LIMITATIONS OF WIMAX
Limitations
A commonly-held misconception is that WiMAX will deliver 70 Mbit/s over 50 kilometers. In reality, WiMAX can do one or the other — operating over maximum range (50 km) increases bit error rate and thus must use a lower bitrate. Lowering the range allows a device to operate at higher bitrates.
Typically, fixed WiMAX networks have a higher-gain directional antenna installed near the client (customer) which results in greatly increased range and throughput. Mobile WiMAX networks are usually made of indoor "customer premises equipment" (CPE) such as desktop modems, laptops with integrated Mobile WiMAX or other Mobile WiMAX devices. Mobile WiMAX devices typically have an omni-directional antenna which is of lower-gain compared to directional antennas but are more portable. In practice, this means that in a line-of-sight environment with a portable Mobile WiMAX CPE, speeds of 10 Mbit/s at 10 km could be delivered. However, in urban environments they may not have line-of-sight and therefore users may only receive 10 Mbit/s over 2 km. In current deployments, throughputs are often closer to 2 Mbit/s symmetric at 10 km with fixed WiMAX and a high gain antenna. It is also important to consider that a throughput of 2 Mbit/s can mean 2 Mbit/s, symmetric simultaneously, 1 Mbit/s symmetric or some asymmetric mix (e.g. 2 Mbit/s downlink and 1 Mbit/s uplink or 1.5 Mbit/s downlink and 0.5 Mbit/s uplink, each of which required slightly different network equipment and configurations. Higher-gain directional antennas can be used with a Mobile WiMAX network with range and throughput benefits but the obvious loss of practical mobility.
Like most wireless systems, available bandwidth is shared between users in a given radio sector, so performance could deteriorate in the case of many active users in a single sector. In practice, many users will have a range of 2-, 4-, 6-, 8-, 10- or 12 Mbit/s services and additional radio cards will be added to the base station to increase the capacity as required.
Because of this, various granular and distributed network architectures are being incorporated into WiMAX through independent development and within the 802.16j mobile multi-hop relay (MMR) task group. This includes wireless mesh, grids, network remote station repeaters which can extend networks and connect to backhaul.
A commonly-held misconception is that WiMAX will deliver 70 Mbit/s over 50 kilometers. In reality, WiMAX can do one or the other — operating over maximum range (50 km) increases bit error rate and thus must use a lower bitrate. Lowering the range allows a device to operate at higher bitrates.
Typically, fixed WiMAX networks have a higher-gain directional antenna installed near the client (customer) which results in greatly increased range and throughput. Mobile WiMAX networks are usually made of indoor "customer premises equipment" (CPE) such as desktop modems, laptops with integrated Mobile WiMAX or other Mobile WiMAX devices. Mobile WiMAX devices typically have an omni-directional antenna which is of lower-gain compared to directional antennas but are more portable. In practice, this means that in a line-of-sight environment with a portable Mobile WiMAX CPE, speeds of 10 Mbit/s at 10 km could be delivered. However, in urban environments they may not have line-of-sight and therefore users may only receive 10 Mbit/s over 2 km. In current deployments, throughputs are often closer to 2 Mbit/s symmetric at 10 km with fixed WiMAX and a high gain antenna. It is also important to consider that a throughput of 2 Mbit/s can mean 2 Mbit/s, symmetric simultaneously, 1 Mbit/s symmetric or some asymmetric mix (e.g. 2 Mbit/s downlink and 1 Mbit/s uplink or 1.5 Mbit/s downlink and 0.5 Mbit/s uplink, each of which required slightly different network equipment and configurations. Higher-gain directional antennas can be used with a Mobile WiMAX network with range and throughput benefits but the obvious loss of practical mobility.
Like most wireless systems, available bandwidth is shared between users in a given radio sector, so performance could deteriorate in the case of many active users in a single sector. In practice, many users will have a range of 2-, 4-, 6-, 8-, 10- or 12 Mbit/s services and additional radio cards will be added to the base station to increase the capacity as required.
Because of this, various granular and distributed network architectures are being incorporated into WiMAX through independent development and within the 802.16j mobile multi-hop relay (MMR) task group. This includes wireless mesh, grids, network remote station repeaters which can extend networks and connect to backhaul.
WIMAX ARCHITUCTURE
Architecture
The WiMAX Forum WiMAX Architecture
The WiMAX Forum has defined an architecture that defines how a WiMAX network connects with other networks, and a variety of other aspects of operating such a network, including address allocation, authentication, etc. An overview of the architecture is given in the illustration. This defines the following components:
* SS/MS: the Subscriber Station/Mobile Station
* ASN: the Access Service Network [8]
* BS: Base station, belongs to ASN
* ASN-GW: belongs to ASN
* CSN: the Connectivity Service Network
* HA: Home Agent, belongs to CSN
* AAA: AAA Server, belongs to CSN
* NAP: a Network Access Provider
* NSP: a Network Service Provider
plus a number of interconnections (or reference points) between these, labeled R1 to R5 and R8.
It's important to note that the functional architecture can be designed into various hardware configurations rather than fixed configurations. For example, the architecture is flexible to allow various scale and functionality of remote/mobile stations and collaborative aggregations of femto, pico, and mini RS/MS.
Subscribe to:
Posts (Atom)